PA-24 TPM Starter Kit

If you’re new to AuthentiKit, got your own 3D printer and would like to build this beautiful and highly specified Throttle, Prop & Mixture control, then this hardware kit is for you. This TPM is a replica based on the Piper Comanche PA-24 and is fully functional with throttle, prop and mixture levers as well as a parking brake. It uses hall sensors for very fine smooth control and hydraulic damping for realistic resistance.

This Starter Kit includes all the hardware you need including the circuit board and parts for an AuthentiKit Universal Hub. If you also need the 3D printed parts please order the All Inclusive Kit instead. If you already have an AuthentiKit Universal Hub then choose the standard Hardware Kit.

This unit mounts to the underside of a desk or table. You will require a table top with maximum depth 40mm and with clearance under the table.

This kit contains the hardware needed to build the AuthentiKit PA-24 Piper Comanche Throttle, Prop & Mixture (T.P.M) control, as well as all required hardware to build the Universal Hub, which is needed to link your control to your PC. The Universal Hub includes the required inputs to connect your T.P.M control to your PC.

Containing

3 x Honeywell Hall Sensors
BU0836A Joystick controller board
1 x Gikfun Microswitch
3 x Neodymium magnets
3 x 6700ZZ Bearings
6 x 684ZZ Bearing
30cm Felt tape
1 x Ball spring plungers
3 x Rotary Damper 400
2 x RJ45 jacks
6 x silicon wire (6 colours)
1 x USB Cable
1 x Ethernet Cable
2 x Desk Clamps
10 x Dupont Cables
30 x Ferrules
Various tools
Screws/bolts

*Please note, this product does not contain the required 3D printed parts and is tailored to those who already own a 3D printer. If you require a kit containing 3D parts and hardware please choose our All Inclusive Kit.

£91.00

18 in stock